Ricoh feeder Manual Do Utilizador

When You Cannot Print

43

If the printing does not start, consult your service representative.

Printing does not start.

If the machine is operat-
ing in an extended wire-
less LAN, the receiver's 
MAC address may be 
preventing communica-
tion with the access point.

Check access point settings when in the 
infrastructure mode. Depending on the 
access point, client access may be limit-
ed by MAC address. Also, check there 
are no problems in transmission be-
tween access point and wired clients, 
and between access point and wireless 
clients.

Printing does not start.

The extended wireless 
LAN has not started.

Confirm the orange LED is lit, and the 
green LED is lit or blinks during trans-
mission.

Printing does not start.

The login user name, log-
in password, or driver 
encryption key is invalid.

Check the login user name, login pass-
word, or driver encryption key.

Printing does not start.

Advanced encryption has 
been set using the Ex-
tended Security function.

Check the settings of the Extended Se-
curity function with the administrator.

Data-in lamp does not 
blink or light up.

If the data-in lamp is unlit 
or not flashing even after 
performing [Print], the 
machine has not received 
the data.

• When the machine is connected to a 

computer via a cable, check the 
computer print port settings are cor-
rect. See “Confirming the Connec-
tion Method”, Printer Reference.

• When it is networked with a com-

puter, Contact the administrator. 

The status indicator of 
the printer is lit.

The cause is displayed on 
the display of the control 
panel.

Check the error message on the display 
panel and take required action. See p.39 
“When a Message Appears”.

“

Updating the desti-

nation list... 

Please wait. Speci-

fied destination(s) 

or sender's name has 

been cleared.

” appears.

The destination list is be-
ing updated from the 
network using SmartDe-
viceMonitor for Admin.

Wait until the message disappears. Do 
not switch off the power while this mes-
sage is displayed. Depending on the 
number of destinations to be updated, 
there may be some delay before you can 
resume operation. Operations are not 
possible while this message is displayed.

 is dis-

abled.

A mechanical error might 
have occurred.

Contact your service representative. 
See “List/Test Print”, General Settings 
Guide.

Printing does not start 
when using the extended 
wireless LAN in Ad-hoc 
mode.

The correct Communica-
tion mode is not set.

Turn the main power off and back on. 
See “Turning On/Off the Power”, 
About This Machine.

Or, change the settings for [System Set-
tings]

, [Interface Settings], and [Network]. 

See “Network Settings”, General Set-
tings Guide.