Rimage Auto Printer RAS10 Manual Do Utilizador

Before installing ribbons in the printer, stop any operations. 

To change ribbons in a Prism printer, refer to the PrismPlus Printer User Guide. 

To change ribbons in an Everest II printer, refer to the Everest II Printer User Guide. 

Once a week. Remove dust from the AutoPrinter and 
surrounding work area. 

Cleaning the AutoPrinter 

Upon installation and again if the discs are not picked 
correctly from the printer tray. Refer to the procedures below 
for more information. 

Aligning the printer 

To align your Everest printer, use the following instructions. 

# 

•  T25 Torx screwdriver 
• 5/32” 

Allen 

wrench 

1.  Power on the AutoPrinter. 

2.  Wait for the unit to complete initialization. When initialization is complete, the active indicator 

light on the Everest printer illuminates. 

 

kes 1 to 2 minutes to complete the initialization.  

Note: The Everest printer ta

3.  Prepare the unit for alignment. 

a.  Manually slide the lift arm to the top of 

the AutoPrinter. 

b.  To place a disc in the gripper, press 

the disc up into the gripper while 
pressing the disc release button. 

c. Release 

the 

disc release button. The 

 

gripper holds the disc. 

d. Press 

the 

printer button to open the 

printer tray. 

110656_H  

7