Polycom Welding System 3725-77601-001H Manual Do Utilizador

Polycom CMA System Operations Guide 

232

Polycom, Inc.

This topic describes how to add an MCU to a CMA system.

When you add an MCU device, MCU network services are added 

automatically at the time the IP card registers with the CMA system. 
When you add a gateway device, use the Services page to specify the network 

services available for the device.

When you enter network service information manually, remember that the 

CMA system does not create the service at the device. The service must have 

already been defined at the device. Enter information in the CMA system that 

matches the information in the device. 
If you do not define network services, you may not use an MCU or gateway in 

a conference. For example, if you do not define the H.323 service on the MCU, 

when the CMA system tries to schedule a video conference that requires this 

service, it will look for another MCU with this service. If another MCU with 

this service is not available, the conference will not be scheduled.

Go to Network Device > MCUs and click Add 

.

In the Add New Device dialog box, select the Device Type of interest. 

For valid types, see 

Enter the IP Address of the MCU.

Enter the Admin ID and Password for the MCU. 

Back-end communication with the RMX control units and IP service blades must be 
enabled.

Polycom RMX devices may only have H.323 service.

Once an MCU registers with the CMA system, if you change an MCU service on 
the MCU, the update does not automatically get sent to the CMA system. To 
update the system, you must delete and read the MCU to the system.

These network services are not the same as the Dial Plan Services such as 
Simplified Dialing and Conference on Demand. Network services describe 
the physical connection that the device supports. Dial plan services provide 
access to specific features used for routing calls by dialing a prefix.