Tyco SafeLINC 4100U Manual Do Utilizador
5-4
Figure 5-1. 4100-6014 Network Interface Card
The 4100-6014 NIC has the following LEDs:
LED1 (yellow). Illuminates when
• The host 4100 requests it to illuminate
• A transmission fails
• It is off-line with the 4100 host
• It needs to be configured
• A transmission fails
• It is off-line with the 4100 host
• It needs to be configured
LED2 (red). Illuminates when a data ‘0’ is received at the right port.
LED3 (green). Illuminates when a data ‘0’ is transmitted at the right port.
LED4 (red). Illuminates when a data ‘0’ is received at the left port.
LED5 (green). Illuminates when a data ‘0’ is transmitted at the left port.
LED3 (green). Illuminates when a data ‘0’ is transmitted at the right port.
LED4 (red). Illuminates when a data ‘0’ is received at the left port.
LED5 (green). Illuminates when a data ‘0’ is transmitted at the left port.
Continued on next page
Introduction to the 4100 Network Interface Card (NIC),
Continued
Network Module
Illustrations
Illustrations
NIC Card LED
Indications
Indications
DATA TRANSMIT/
RECEIVE LEDs
(LED2 THROUGH
LED5)
MEDIA CARD
40-PIN
CONNECTORS
(P5, P6)
DATA RATE JUMPER
PORT (P3)
DATA
PROTOCOL
JUMPER PORT
(P3)
ADDRESS DIP
SWITCH (SW2)
DIAL-UP
SERVICE
MODEM
CONNECTOR
(P2)
SERVICE
MODEM
CONNECTOR
(P2)
RESET SWITCH
(SW1)
MOTHERBOARD
CONNECTOR (P4)
CONNECTOR (P4)
YELLOW LED
(LED1)