Tripp Lite SNMP Solo MT-SE-37/02 Manual Do Utilizador
Tripp Lite
Configuration
11
Configuration
You have previously installed the UPS, and you are ready to
configure the SNMP Solo to work on your network. SNMP Solo
is temporarily connected to a PC with a terminal emulation
package or to a dumb terminal.
configure the SNMP Solo to work on your network. SNMP Solo
is temporarily connected to a PC with a terminal emulation
package or to a dumb terminal.
NOTE:
Refer to the Installation section for the proper setting of the
hardware adapter prior to configuring the device.
hardware adapter prior to configuring the device.
Press any key to display the Main Menu. From this menu you
can select to enter the IP address, Gateway address, and MIB
system group; you can set the access controls of SNMP
communities; set traps, display settings; reset the settings to
default values; save the new values and exit the program, and
upgrade Firmware (See caution in the Upgrade Firmware
section); and exit without saving.
can select to enter the IP address, Gateway address, and MIB
system group; you can set the access controls of SNMP
communities; set traps, display settings; reset the settings to
default values; save the new values and exit the program, and
upgrade Firmware (See caution in the Upgrade Firmware
section); and exit without saving.
Figure 5 Main Menu
To select any option on the Main Menu, enter the number of the
option you want at the Choose a Number=> prompt. The
program displays the desired screen.
option you want at the Choose a Number=> prompt. The
program displays the desired screen.