Tripp Lite SNMP Solo MT-SE-37/02 Manual Do Utilizador
SNMP Solo
18
Configuration
To remove a trap receiver from the list, type clear, <space>,
and the desired list number at the prompt. Press <enter>.
and the desired list number at the prompt. Press <enter>.
The top of the screen reflects your changes:
To return to the Main Menu, type 0 at the prompt and press
<enter>.
<enter>.
Additional Setup Screen
To set your UPS address, type 4 and press Enter. This will
bring up the menu shown in Figure 9.
bring up the menu shown in Figure 9.
Figure 9 Additional Setup Screen
You need to set the UPS address. This address should match
the address you assigned to the UPS when you installed the
UPS. This address will determine which UPS the SNMP
adapter communicates with. You can set the address by typing
2 <0-127>
the address you assigned to the UPS when you installed the
UPS. This address will determine which UPS the SNMP
adapter communicates with. You can set the address by typing
2 <0-127>
and pressing Enter. Choose the number 0-127
that corresponds to the UPS address.