Triax DVB 75SI Manual Do Utilizador
TRIAX DVB 75SI
12
If you get a clear picture from the satellite receiver, you must then
set your satellite receiver to use another transmitter channel in the
range from channel 21 to channel 69 (see below).
set your satellite receiver to use another transmitter channel in the
range from channel 21 to channel 69 (see below).
6HWWLQJRIWKH8+)RXWSXWFKDQQHO
NOTE: A change of the UHF output channel of the satellite receiver
requires a change of setting via the main menu of the receiver. The
UHF output channel can only be seen when the TV is set to channel
38 as described above.
requires a change of setting via the main menu of the receiver. The
UHF output channel can only be seen when the TV is set to channel
38 as described above.
If the setting above results in an unsatisfactory picture, you must
temporarily remove the aerial cable from the antenna/modulator
input (ANT IN) of the satellite receiver. This is the only way to make
sure that you can use the UHF channel 38 set to temporarily display
the main menu of the satellite receiver on the screen to enable you
to make the necessary changes.
temporarily remove the aerial cable from the antenna/modulator
input (ANT IN) of the satellite receiver. This is the only way to make
sure that you can use the UHF channel 38 set to temporarily display
the main menu of the satellite receiver on the screen to enable you
to make the necessary changes.
• Activate the main menu of the receiver by
pressing the [menu] button on the remote
control.
control.
The main menu now appears on the screen, and
the top menu line with the text ‘TV programmes’
is clearly marked to appear different from the
lines below. (See chapter 4.2, page 20)
the top menu line with the text ‘TV programmes’
is clearly marked to appear different from the
lines below. (See chapter 4.2, page 20)
• In the main menu you must now mark up the
menu line ’Settings’ by moving the marking on
the screen downwards by means of the
cursor/arrow buttons [arrow down] of the
remote control until the line ‘Settings’ is marked
and highlighted.
the screen downwards by means of the
cursor/arrow buttons [arrow down] of the
remote control until the line ‘Settings’ is marked
and highlighted.
• Confirm the choice by pressing the [OK] button
of the remote control. Now the submenu
’Settings’ will appear on the screen.
’Settings’ will appear on the screen.
• Mark up the menu line ’Audio/Video Settings’
in the same way.
• Confirm the choice by pressing the [OK] button
of the remote control. Now the submenu ’Audio/-
Video Settings’ will appear on the screen.
Video Settings’ will appear on the screen.
• Now select the menu line ’UHF output channel’
by marking up this line by means of the [arrow
buttons] of the remote control.
buttons] of the remote control.
• Now you can enter the new UHF output channel
that you want to use on your TV by entering the
number of the channel directly via the numerical
buttons [0-9] (channel 21 to channel 69) on the
remote control.
number of the channel directly via the numerical
buttons [0-9] (channel 21 to channel 69) on the
remote control.