Telit Wireless Solutions GE863-QUAD Manual Do Utilizador

 
 
 
 

 

 

 1vv0300715 Rev. 1 - 19/09/06  

  

Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved 

 

page 16 of 79 

 

4.2 General Design Rules 

The principal guidelines for the Power Supply Design embrace three different design steps: 
- the electrical design 
- the thermal design. 
- the PCB layout. 

4.2.1 

 Electrical design Guidelines 

The electrical design of the power supply depends strongly from the power source where this power is 
drained. We will distinguish them into three categories: 
•   +5V input   (typically PC internal regulator output) 
•  +12V input (typically automotive) 
•  Battery 
 

4.2.1.1  + 5V input Source Power Supply Design Guidelines 

•  The desired output for the power supply is 3.8V, hence there's not a big difference between the 

input source and the desired output and a linear regulator can be used. A switching power supply 
will not be suited because of the low drop out requirements. 

•  When using a linear regulator, a proper heat sink shall be provided in order to dissipate the power 

generated. 

•  A Bypass low ESR capacitor of adequate capacity must be provided in order to cut the current 

absorption peaks close to the GE863-QUAD/PY, a 100μF tantalum capacitor is usually suited. 

•  Make sure the low ESR capacitor on the power supply output (usually a tantalum one) is rated at 

least 10V. 

•  A protection diode should be inserted close to the power input, in order to save the GE863-

QUAD/PY from power polarity inversion.