Tektronix Webcam 070-8030-01 Manual Do Utilizador

Adjustment Procedures

1780R-Series Service Manual

o. Set the generator output frequency to 3.58 MHz (4.43 MHz for PAL),

5 MHz, 8 MHz, and then to 10 MHz.

p. Check that the displayed amplitude on the Waveform CRT is within 

±

3%

or 

±

21.4 mV for NTSC (

±

21.0 mV for PAL) of the amplitude noted in

part l. of this step for each frequency given in part o.

q. Remove the 10X attenuator so that the signal is applied through the

50 

W-to-75 W minimum loss attenuator and 75 W feed-through termina-

tor to the PROBE input.

Check that the CONFIGURE button is On. Select PROBE-X1 on PAGE
2 of the menu.

Repeat parts l. through p. to check the probe X1 frequency response.

Disconnect the equipment from the PROBE input connector.

u. Disconnect the 75 

W termination from the PIX MON OUT connector.

This completes the Adjustment Procedure.