Over And Back PAP2 Manual Do Utilizador

Phone Adapter with 2 Ports for Voice-over-IP

5

Chapter 3: Connecting the Phone Adapter

This chapter gives instructions on how to connect the Phone Adapter to your network and telephones or fax 
machines. Shown below is a connection diagram displaying a typical setup.

This chapter also describes the Phone Adapter’s placement options. You can place it flat on a surface, attach 
the Phone Adapter’s base so it can stand in place, or mount the Phone Adapter on a wall.

If you already have an account set up with Vonage, then proceed to step 1.

If you do not have an account, visit www.vonage.com to activate the Phone Adapter. After you have set up an 
account, then proceed to step 1.

The Phone 

Adapter includes a ringer (ring 
signal generator), which is a 
source of hazardous voltage. 
When the ringer is activated by 
an incoming call, do not touch 
the Phone port wires, the wires 
of a cable connected to either 
of the Phone ports, or the 
internal circuitry of the Phone 
Adapter.

Telephone

Router

Cable/DSL 

Modem

Internet

Phone Adapter

Do not connect 

either of the Phone ports to a 
telephone wall jack. Make sure 
you only connect a telephone or 
fax machine to either of the 
Phone ports. Otherwise, the 
Phone Adapter or the telephone 
wiring in your home or office 
may be damaged.