Omron SYSMAC C200HW-ZW3AT2-E-V2 Manual Do Utilizador
5-3
Section
L: Data Link
62
3. Specify the nodes to be checked. Use the Cursor Keys to move the cursor to
the node to be checked, then press the Enter Key. “Yes” will be displayed to
represent the nodes to be checked.
represent the nodes to be checked.
To deselect a node to be checked, move the cursor to a node marked with
“Yes,” then press the Enter Key again. “Yes” will be erased to deselect the
node.
“Yes,” then press the Enter Key again. “Yes” will be erased to deselect the
node.
4. After specifying all the nodes to be checked, press the F6 (Execute) Key.
The data link tables will be checked and the check results screen will be dis-
played.
played.
Each error level is indicated by a different character color as follows:
Red: Error
White: Warning
White: Warning
A message is displayed in the lower part of the screen according to the
check results as follows:
check results as follows:
When no errors has been detected: “Check OK”
When errors are continued on the next page: “Continue”
When the current page is the last page of the error display: “Last page”
When errors are continued on the next page: “Continue”
When the current page is the last page of the error display: “Last page”
5. When errors are displayed on multiple screens, use the following keys to
switch the screen and display the check results. F4 (Pre Pg), F5 (Nxt Pg), F8
(Pre Node), F9 (Nxt Node), Page Up, and Page Down
(Pre Node), F9 (Nxt Node), Page Up, and Page Down
6. After confirming the check results, press the F10 (End) Key.