Nortel Networks Passport 8001PS Manual Do Utilizador

1

This guide provides the following information:

•

Operational notes

•

Instructions for installing a Passport 8001PS AC Power Supply in an unoccupied bay of the 
Passport 8010 Chassis

•

Instructions for replacing an installed power supply in the Passport 8010 Chassis

•

Specifications for the power supply

For more information about the Passport

™

 chassis, refer to Installing the Passport 8010 Chassis 

(part number 204518-B). 

A Passport 8010 Chassis with up to five installed modules can operate with one installed power supply. 
For a redundant power configuration, install two power supplies.

A Passport 8010 Chassis with more than five installed modules requires a minimum of two power 
supplies for a nonredundant configuration. A redundant configuration for such a chassis requires three 
power supplies.

In a chassis with a nonredundant power supply configuration, if one power supply fails, the system 
loses power and network connectivity.

In a chassis with two installed power supplies, you can add a third power supply without powering 
down the chassis.

When you first install a Passport 8000 Series chassis that requires two power supplies (nonredundant 
configuration), you must turn on both power supply units within 2 seconds of each other. If you wait 
longer to turn on the second power supply, both power supplies will latch off. To correct this condition, 
turn off both power supplies, wait at least 30 seconds, and turn both power supplies on again within 
2 seconds.