Nlynx ETU400 Manual Do Utilizador

ETU400 User Guide 011603

 

Some users of ETU/400 may be more familiar with the operating system of

System/36 than with that of the AS/400. For this reason, ETU/400 supports

a set of commands in System/36 mode, in addition to the native AS/400

commands.

The commands that are supported in both the native mode and System/36

mode are listed in this chapter. Any native command can be used by a

System/36-mode OCL procedure. The syntax of the native command when used

in OCL is the same as entering the command from the System/36-mode

command line (all uppercase letters).

However, most native commands do not return status codes in the LDA so

the abnormal completion of a native command cannot be detected by the OCL

procedure. For this reason, System/36-specific commands 

are available in ETU/400.

This appendix describes how to access the System/36-mode menu and how to

execute the commands. Finally, this appendix describes each command

available in Sytem/36 mode, listed in alphabetical order.