New Buck Corporation 81 Manual Do Utilizador

1.  Inspect the unit for any obvious physical damage. 
 
NOTE:  Plug the power cord into a 115V AC outlet to test the fan and motor.  Set switch to 
“Manual” and rheostat to “High” position to ensure motor operates properly.  Route the cord to 
prevent damage to the cord insulation from heat and sharp objects.  Keep the cord out of the 
way of traffic to  prevent damage caused by tripping, etc.  
 
2.   Check the primary air draft control to ensure that it  slides freely. 
 
3.  Remove any items from within the firebox.  Spread  the  drop cloth  on the floor behind the 

heater.  Next, tilt the heater  so that the back is on the drop cloth. 

 
4.  If leg kit is to be used follow steps 1-3. Then obtain legs, bolts, washer & nuts. Attach the 

legs to holes in bottom of unit. 

 
5.  If pedestal kit is being used, open the corresponding  freestanding  kit and obtain the stand.  

Place the stand against  the bottom  of the heater (angle side to heater) at the marked  line.  
Center  the  stand  left and right and mark  screw  locations  on bottom  through outer holes 
of stand mounting angles.  Set  stand aside  and drill four 7/32" holes in heater bottom.  
(See  Figure 4.) 

 

 
 
 
 
 
 
 
 
 
 
 
 
 

Figure 4 

 

6.  Obtain four 1/4" self-tapping screws and secure the stand  to the heater. 
 
7.  Reposition the heater to the upright position. 
 

13