NewAir APH-4000PV Manual Do Utilizador

Página de 15
                      
 
 
operating instructions. If any time gas odor is detected, shot off the 
appliance immediately, find and correct the leak. Please set up the propane 
supply with utmost care. 
Alert both children and elders to the hazard of high surface emperatures. 
    Care must be taken for the supervision of children in the vicinity of an 
    operating or hot heater. 
 Your children and pets should be supervised when they are in area of 
    heater. 
This outdoor patio heater must be used for outdoors only in a well 
    ventilated area and not be used in a vehicle or any enclosed building. 
Always place the heater on a level stable surface. 
Do not move, touch the heater while hot or burning. 
Do not alter or modify the heater in any manner 
  Use only a U.S. Department of Transportation approved 20 pound 
    standard cylinder equipped with an TYPE 1 connection with QCC 
    (Quick Connect Coupler). 
Use only with propane / LP Gas. Do not attempt to use any other fuel. 
Always keep at least a 24 ‘’ clearance from any combustible material. 
Do not use if the wind velocity is greater than 10 miles/hr. 
Do not use if the environment temperature is below 40 F. 
Do not spray aerosols near the heater while in use. 
Do not clean heater with combustible or corrosive cleaners.  Use warm, soapy 
    water. 
Do not hang clothing or flammable materials either on or near heater 
  Do not move, touch the heater while it is hot or in operation. 
Place the control knob on OFF position when heater is not in use and always 
    disconnect the gas cylinder at its main valve and store it outdoors where it is 
    not accessible to children.  Never store a propane cylinder indoors 
Always 45 minutes to cool down after use before attempting to move your 
    heater. 
  Use only the hose and regulator with the heater provided by the factory. Check 
    the regulator and hose assembly before each use. If you find an excessive 
    abrasion or hose is cut, please replace with the Regulator assembly listed on 
    the parts list right away. 
Never use the heater if the ballast weight is not assembled into the base. The 
    base must be weighted to prevent possible tipping. 
Inspect heater before each use and inspect annually by a qualified service 
    person. Do not operate a damaged heater. 
  Leak check only with soapy water when the initial assembly and after every 
    cylinder is replaced.  All gas connections should be checked. Look for bubbles. 
     
Never use flame! 
 
Warning:  
When the heater is to be operated in the presence of other people, the user is