National Instruments NI 1450 Series Manual Do Utilizador

© National Instruments Corporation

Figure 2-1.  Connection Sequence

•

Set up the hardware—This section explains how to connect a camera, 
monitor, and power supply to the NI 1450.

•

Set up the development computer—This section explains how to use 
either Vision Builder AI or LabVIEW Real-Time with the Vision 
Development Module to perform the following tasks:

–

Connect the NI 1450 to the development computer

–

Install application and driver software

–

Obtain an IP address

•

Acquire an image—This section explains how to use either Vision 
Builder AI or LabVIEW Real-Time with the Vision Development 
Module to acquire an image.

Use a standard Category 5 or Category 6 Ethernet cable to connect the 
NI 1450 to an Ethernet network.

If the development computer is already configured on a network, you must 
configure the NI 1450 on the same network. If the development computer 
is not connected to a network, you can connect the two directly using a 
Category 5 or Category 6 crossover cable.

To prevent data loss and to maintain the integrity of your Ethernet installation, 

do not use a cable longer than 100 m. If you are using a 100 Mbps Ethernet, National 
Instruments recommends using a Category 5 or Category 6 shielded twisted-pair 
Ethernet cable.

or

or

Set Up the Development

Computer Using 

Set Up the Development

Computer Using LabVIEW 

Real-Time with the  Vision 

Acquire an Image Using 

Acquire an Image Using 

Set Up the Hardware