Keyspan URM-17A Manual Do Utilizador
Attach the Keyspan USB Cable's "A" connector (rectangular connector) to the USB port on your
computer or your Airport Express.
computer or your Airport Express.
TROUBLESHOOTING: STATUS LIGHTS: MAC & WINDOWS: When connecting the
Remote for iTunes Receiver to your Mac or Windows computer, you should notice a red light turn
on and then turn off. This indicates the Keyspan Remote for iTunes is ready for use. If the light
does not turn off, disconnect the Receiver and reinstall the Keyspan software. If the problem
persists, please contact Keyspan Technical Support. Please note that this does not apply for
users connecting their Remote for iTunes receivers to Airport Express.
Remote for iTunes Receiver to your Mac or Windows computer, you should notice a red light turn
on and then turn off. This indicates the Keyspan Remote for iTunes is ready for use. If the light
does not turn off, disconnect the Receiver and reinstall the Keyspan software. If the problem
persists, please contact Keyspan Technical Support. Please note that this does not apply for
users connecting their Remote for iTunes receivers to Airport Express.
Step 3
-
IMPORTANT
- Remove the battery protector film from the Remote for iTunes Remote Control
Before you can start using your Remote, you will need to remove the clear battery protector film
that separates the Remote's batteries (that are located on the back of the remote in the battery
compartment). This protector prevents the batteries from being drained before you receive the
that separates the Remote's batteries (that are located on the back of the remote in the battery
compartment). This protector prevents the batteries from being drained before you receive the
Remote for iTunes.
First, remove the battery cover on the back of the Keyspan Remote for iTunes Remote Control (see
image below). Then remove clear plastic film and finally replace the battery cover.
image below). Then remove clear plastic film and finally replace the battery cover.
MAC & WINDOWS USERS:
To test your remote and receiver hardware, point your remote control to the receiver and PRESS
AND HOLD ANY BUTTON on the remote control. This will cause the receiver's status light to
AND HOLD ANY BUTTON on the remote control. This will cause the receiver's status light to
blink rapidly (several times per second). This indicates that the remote is sending IR (aka infrared)
commands to the receiver and that the receiver is receiving them.
commands to the receiver and that the receiver is receiving them.
TROUBLESHOOTING: STATUS LIGHTS: MAC & WINDOWS: If you get a different
behavior, please contact Keyspan Technical Support.
Now that you have installed the Keyspan Remote Software and hardware, please proceed to Using
Your Remote for iTunes.
Your Remote for iTunes.
Uninstall Instructions
Keyspan: Remote for iTunes - User Manual (Mac OS X & Windows)
This User Manual applies to the Keyspan Remote for iTunes Software Version 2.3
Rev 2005jun01
Page 6