Kenwood TS-2000 Manual De Instruções

97

You will require a Phillips screwdriver when installing
the optional units.

When installing the optional DRU-3A or VS-3 unit,
remove the bottom case first.

1 Remove the 10 screws.

2 Lift off the bottom case.

SWITCH OFF THE POWER AND UNPLUG THE DC POWER
CABLE BEFORE BEGINNING INSTALLATION.

1 Remove the bottom case (10 screws).

2 Locate the DRU-3A connector.

3 Peel off the paper on the cushion attached to the

PC board of the transceiver.

4 Plug the DRU-3A into the DRU-3A connector of

the PC board.

5 Press the top of the DRU-3A to affix it to the

cushion.

DRU-3A

6 Replace the bottom case (10 screws).

Note:  After the installation, you can adjust the DRU-3A playback
volume by selecting Menu No. 14.

SWITCH OFF THE POWER AND UNPLUG THE DC POWER
CABLE BEFORE BEGINNING INSTALLATION.

1 Remove the bottom case (10 screws).

2 Locate the VS-3 jack.

3 Hold the VS-3 unit with the component side facing

up, and insert the VS-3 connector into the VS-3
jack.

4 Replace the bottom case (10 screws).

Note:  After the installation, you can adjust the VS-3 playback volume
by selecting Menu No. 15.

Cushion