Kenwood MGR-E8 Manual Do Utilizador

Página de 84
MGR-E8
36
Changing the Recording Settings
Item
Setting
Setting overview
Int.
 Mic
Ex
t. M
ic
Li
ne
 Mic Sync Rec
OFF*/ON
Recording starts in synchronism with the 
start of microphone sound input. Recording 
pauses when no sound has been input for 
2 seconds.
This item is enabled when [MIC REC LEVEL] 
is set to AUTO.
● ●
 Analogue  limiter OFF*/ON
When high-level sound is input suddenly 
while this item is set to ON, the recording 
level is automatically adjusted to prevent 
distortion of the recorded audio. 
This item is enabled when [MIC REC LEVEL] is 
set to MANUAL.
● ●
Low-cut filter
OFF*/ON
Set to ON to reduce noise from the air 
conditioner or blowing wind by cutting off 
the low frequencies.
● ●
 Delay  Rec
OFF*/5sec/10sec/30sec
Set the delay time reserved before actual 
recording starts after [REC] is pressed. This 
is convenient when preparation is required 
before starting recording, for example for 
checking the musical instruments, etc.
● ● ●
Line auto divide
OFF*/ON
When this item is ON, recording on a new 
file begins when no sound has been input for 
2 seconds.
Auto divide level High/Mid*/Low
Set the level for detecting the beginning 
of music.
(* : Factory setting)
• Since the <Mic Sync Rec> and <Line auto divide> recordings start after the 
start of audio is detected, the initial section of the audio may not be recorded. 
To prevent this, do not use these settings for important recordings. It is 
recommended to record a single file and divided it later. (page 40)
B60-5825-08_00_MGR-E8(E)_English_1AJ6P1P0109--(XE0).indd   36
B60-5825-08_00_MGR-E8(E)_English_1AJ6P1P0109--(XE0).indd   36
10/08/04   13:48
10/08/04   13:48