Juniper Networks Security Threat Response Manager 5000 Manual Do Utilizador

Fan Modules

NetScreen-5000 Series 

5

F

AN

 M

ODULES

The NetScreen-5200 has a three-fan module and the NetScreen-5400 has a two-fan 
module. You can access the fan module from the left front side of each chassis.

To remove the NetScreen-5200 fan module, turn the fan knob in the unlock 
position, then gently pull the fan module lever toward you to slide the module 
out.

To remove the NetScreen-5400 fan module, loosen the two thumb screws that 
secure the fan module, then gently slide the module out.

If a fan stops operating due to failure or removal, then the system continues to run and 
generates an alarm. When you replace the fan, do not leave the fan tray empty for more 
than two minutes. See 

 for more information.

N

ET

S

CREEN

-5000 M

ODULES

The NetScreen-5000 Series systems support two module types:

NetScreen-5000 management modules

NetScreen-5000 Secure Port Modules (SPMs)

The following table shows the modules supported by each slot.

The following table shows the configurations for each Management Modules and Secure 
Port Module and shows if the firmware version is included on the Management Module or 
needs to be downloaded.

Management 
Module

Secure Port 
Module

N/A

N/A

Management 
Module

Secure Port 
Module

Secure Port 
Module

Secure Port 
Module

5000-MGT

5000-MGT2

5000-MGT2

5000-8G and/or 
5000-2G24FE

5000-8G and/or 
5000-2G24FE

5000-8G2 and/or 
5000-2XGE

Software is installed on 
the shipping 
management module. 

Software is installed on 
the shipping 
management module

Must download from the 
support site. 

www.juniper.net/
support