Juniper Networks SRX 210 Manual Do Utilizador

Related Topics

■

■

■

■

■

Connecting the Modem at the SRX210 Services Gateway End

NOTE: These instructions use Hayes-compatible modem commands to configure the
modem. If your modem is not Hayes-compatible, refer to the documentation for
your modem and enter the equivalent modem commands.

To configure the modem on the services gateway end:

1.

Connect the modem to a PC or laptop computer.

2.

Power on the modem.

3.

From the PC or laptop computer, start your asynchronous terminal emulation
application (such as Microsoft Windows HyperTerminal) and select the 

COM

 port

to which the modem is connected (for example, 

COM1

).

4.

Configure the port settings shown in Table 35 on page 97.

Table 35: Port Settings to Configure the Modem on the Services Gateway End

Value

Port Settings

9600

Bits per second

8

Data bits

None

Parity

1

Stop bits

None

Flow control

5.

In the HyperTerminal window, enter 

AT

.

For more information on the AT commands, see the JUNOS Software
Administration Guide.

An 

OK

 response verifies that the modem can communicate successfully with the

COM

 port on the PC or laptop.

6.

Configure the modem to answer a call on the first ring by entering 

ATS0=1

.

Connecting the Modem at the SRX210 Services Gateway End

■

97

Chapter 15: Connecting the SRX210 Services Gateway to Management Devices