Morgan & Company HEARTHSTONE 8470 Manual Do Utilizador

HearthStone Quality Home Heating Products, Inc. ®                                                                                                                                                                       Morgan Model 8470            

5

dollar bill.  If the bill pulls out without any resistance, 
then your stove’s door isn't sealed properly.  To 
tighten the seal, change the door gasket 

 
At the End of Every Season: 

•  Dismantle the chimney connector and clean it 

thoroughly.  Replace any pieces that show signs of 
rust or deterioration. 

•  Inspect and, if necessary, clean your chimney. 

•  Thoroughly clean out the inside of the Fireplace 

Insert. 

•  Inspect all door gasket material and replace if worn, 

frayed, cracked or extremely hard. 

 

If you have a stovepipe or chimney fire, follow these 
instructions: 

 

1.  If the fire is too threatening, leave the area and call 

the fire department immediately!  If not, perform the 
next two steps. 

 

2.  Close the primary air control. 

 

3.  Keep the Fireplace Insert door closed! 

 
 

•  WARNING 

DO NOT ATTEMPT TO PUT OUT A STOVEPIPE 
OR CHIMNEY FIRE BY THROWING WATER 
ONTO THE STOVE, STOVEPIPE, OR 
CHIMNEY.  THE EXTREMELY HIGH 
TEMPERATURE ASSOCIATED WITH SUCH 
FIRES CAN CAUSE INSTANTANEOUS STEAM 
AND SERIOUS BODILY HARM. 

 
 
Once the chimney fire has expired, leave the primary air 
control closed and let the fire in the Fireplace Insert die 
out completely.  The Fireplace Insert should not be fired 
again until the Fireplace Insert, stovepipe, and chimney 
are all thoroughly inspected for any sign of damage.  You 
must correct any damage before using your Fireplace 
Insert again. 
 
To remove the Morgan for inspection purposes, simply 
disconnect the venting from inside the firebox. Carefully 
remove the surround from the insert, and slide the insert 
away from the fireplace.