Mitel WAP54GP Manual Do Utilizador

13

Chapter 6: Configuring the Wireless-G Access Point with 

Power Over Ethernet

This chapter is a detailed reference guide for the Web-based Utility. You do not need the Utility to start using your 
Access Point. The Access Point has been designed to be functional right out of the box with the default settings. 
However, if you'd like to change your settings, you can use the Utility.

The first screen that appears is the Setup screen. This allows you to change the Access Point's general settings.

Setup

Enter names for the Access Point. The host name can be used to access the Web Utility through the network if 
DNS has been set up. The device name is for the benefit of identifying your Access Point after you log in.

Host Name. The host name assigned to the Access Point. This host name will be published to DNS server if the 
Access Point is configured to acquire the IP address through DHCP. In that case, it is recommended to follow the 
company policy on the host name assignment. The default name is Linksys.

Device Name. You may assign any device name to the Access Point.  This name is only used by the Access Point 
administrator for identification purposes. Unique, memorable names are helpful, especially if you are employing 
multiple access points on the same network. The default name is WAP54GP.

Network Setup

The selections under this heading allow you to configure the Access Point’s IP address setting(s).

IP Settings

Select Static IP Address (default) if you want to assign a static or fixed IP address to the Access Point. Then 
complete the following:

•

IP Address. The IP address must be unique to your network. The default IP address is 192.168.1.245.

•

Subnet Mask. The Subnet Mask must be the same as that set on the LAN that your Access Point is connected 
to. The default is 255.255.255.0.