Measurement Specialties PCI-DAS1002 Manual Do Utilizador
PCI-DAS1002 User's Manual
Installing the PCI-DAS1002
Configuring the hardware
All hardware configuration options on the PCI-DAS1002 are software controlled. You can select some of the
configuration options using InstaCal, such as the analog input configuration (16 single-ended or eight
differential channels), and the source for the two independent counters. Once selected, any program that uses
the Universal Library will initialize the hardware according to these selections.
configuration options using InstaCal, such as the analog input configuration (16 single-ended or eight
differential channels), and the source for the two independent counters. Once selected, any program that uses
the Universal Library will initialize the hardware according to these selections.
For general information regarding analog signal connection and configuration, refer to the Guide to Signal
Connections (available on our web site at
Connections (available on our web site at
Differential input mode
When all channels are configured for differential input mode, eight analog input channels are available. In this
mode, the input signal is measured with respect to the low input. The input signal is delivered through three
wires:
mode, the input signal is measured with respect to the low input. The input signal is delivered through three
wires:
The wire carrying the signal to be measured connects to CH# IN HI.
The wire carrying the reference signal connects to CH# IN LO.
The third wire, typically a system ground, connects to LLGND.
Single-ended input mode
When all channels are configured for single-ended input mode, 16 analog input channels are available. In this
mode, the input signal is referenced to the board's signal ground (LLGND). The input signal is delivered
through two wires:
mode, the input signal is referenced to the board's signal ground (LLGND). The input signal is delivered
through two wires:
The wire carrying the signal to be measured connects to CH# IN HI.
The second wire connects to LLGND.
Connecting the board for I/O operations
Connectors, cables – main I/O connector
The table below lists the board connectors, applicable cables, and compatible accessory boards for the PCI-
DAS1002.
DAS1002.
Board Connectors, cables, accessory equipment
Connector type
100 pin high density Robinson Nugent connector
Compatible cables
C100FF-x, unshielded ribbon cable. x = length in feet (Figure 2 on on page 15)
Compatible accessory products
(with the C100FF-x cable)
(with the C100FF-x cable)
ISO-RACK16/P
ISO-DA02/P
CIO-ERB08 (DADP-5037 adaptor required *)
CIO-ERB24 (DADP-5037 adaptor required *)
SSR-RACK08 (DADP-5037 adaptor required *)
SSR-RACK24 (DADP-5037 adaptor required *)
BNC-16SE
BNC-16DI
CIO-MINI50 (2 required)
CIO-TERM100 (1 required)
SCB-50 (1 required)
ISO-DA02/P
CIO-ERB08 (DADP-5037 adaptor required *)
CIO-ERB24 (DADP-5037 adaptor required *)
SSR-RACK08 (DADP-5037 adaptor required *)
SSR-RACK24 (DADP-5037 adaptor required *)
BNC-16SE
BNC-16DI
CIO-MINI50 (2 required)
CIO-TERM100 (1 required)
SCB-50 (1 required)
* Details on the DADP-5037 adaptor board are available on our web site at
12