LOEWE Individual Sound Projector Manual Do Utilizador
- 18
After auto set-up has been completed, a message will appear
on the screen.
on the screen.
Example 1 - successful auto set-up:
MEASUREMENT COMPLETE
BEAM MODE : 5 BEAM
SUBWOOFER : NOT APPLICABLE
[END] : Do not save set-up.
[OK] : Save set-up.
AUTO SETUP
Example - failed auto set-up:
MEASUREMENT COMPLETE
ENVIRONMENT CHECK [FAILED]
BEAM MODE : 5 BEAM
SUBWOOFER : NOT APPLICABLE
[END] : Do not save set-up.
[OK] : Save set-up.
AUTO SETUP
➠
If the message Error E-1 is displayed, repeat the autoset-up process. Please also
read the "Error messages for auto set-up" on page 6.
OK Apply results of auto set-up .
Remove the microphone from the Sound Projector now.
The Sound Projector is now ready.
You will find information on operating the Sound Projector
from page 19 onwards.
from page 19 onwards.
Saving sound set-up
You can save up to three sound set-ups. This allows you, for example, to take
different listening positions, the actual room or TV positions into consideration
when using a Loewe TV with swivel caster control. You can than call up these
sound set-ups at any time.
You can save up to three sound set-ups. This allows you, for example, to take
different listening positions, the actual room or TV positions into consideration
when using a Loewe TV with swivel caster control. You can than call up these
sound set-ups at any time.
Press the button for a long time. The menu MEMORY
appears.
appears.
1) LOAD
2) SAVE
[] / [] : Up / Down
[OK] : Enter
MEMORY
56
Select the option SAVE.
Confirm OK.
MEMORY1
MEMORY2
MEMORY3
[] / [] : Select
[OK] : Enter
2) MEMORY SAVE
56
Select the option MEMORY1-3.
Confirm OK.
➠
All settings you adjusted in the Sound Projector menus are permanently
stored by saving.
Initial set-up