Logic 3 V5.00 Manual Do Utilizador

3xLogic Vigil System Server Software - User’s Guide    Doc# 08100610 Page 

88 

 

The “Hardware” tab informs Vigil Server of the specific hardware you may have installed as well as configures 

the automated time synchronization. 
 

 

 

This setting restricts the amount of data the video capture card is allowed to push 

through the PCI bus.  The default setting is 20 or 22.5 MB/s, depending upon the 
capture card.  Setting this too high will result in poor performance of the DVR. 

 

 

  If this setting is changed, undesired side effects may result.  

Please consult 3xLogic technical support for more information before changing this 
setting. 

Restricts the combined total frame rate for all network cameras.  The default setting 
is 64 FPS. Setting this too high will result in poor performance of the DVR. 

Keyboard Settings  Allows  you  to  add,  edit,  or  remove  a  special camera control keyboard, such as the 

Pelco KBD300A. 

Opens the AUX Device Settings window for configuring other attached devices such 
as DIO boards or encoders. 

Vigil Server can connect to a time server to synchronize the DVR time.  When 

enabled, you can select to sync with either an NTP server or to another PC that can 
respond to a NET TIME request.  You must specify which NTP or NET TIME PC to 

synchronize with. 
 
Here are some suggested NTP servers to utilize: 

time.nist.gov 192.43.244.18  Boulder, 

CO 

time-nw.nist.gov 131.107.1.10 Washington, 

DC 

time.windows.com 207.46.232.189  Redmond, 

WA 

 

Attempts to synchronize the time on the DVR system immediately.  It may take a 
few minutes to complete the request. 

Opens the Windows Event Viewer.  You can use this to verify that the time 

synchronization took place correctly.  Open the System Event Log and look for an 
entry with Source “W32Time” at the top of the list.