Lexicon PCM92 Manual Do Utilizador
5
the ReAR PANeL
1. POwER JACK
Standard 3-pin IEC power connector. 100-240V, 50-60Hz automatic
switching to correct voltage range.
Standard 3-pin IEC power connector. 100-240V, 50-60Hz automatic
switching to correct voltage range.
2. ETHERNET INPuT
This RJ-45 connection is used to network PCM92 devices and control them
via Ethernet.
This RJ-45 connection is used to network PCM92 devices and control them
via Ethernet.
3. MIDI IN
Receives MIDI information from other MIDI equipment such as master
keyboard controllers, MIDI foot controllers, sequencers and synthesizers.
keyboard controllers, MIDI foot controllers, sequencers and synthesizers.
MIDI THRu
Passes any MIDI data received without change.
Passes any MIDI data received without change.
MIDI OuT
Transmits MIDI data to other equipment.
Transmits MIDI data to other equipment.
4. AES/EBu In/Out
AES/EBU format digital connectors conform to AES professional standards.
AES/EBU format digital connectors conform to AES professional standards.
5. ANALOG IN/OuT
Output impedance is 30
Output impedance is 30
Ω, electronically balanced, and levels up to +20dBu
maximum full scale.
6. FOOT CONTROLLER/FOOTSwITCH JACKS
Functionality to be implemented in a future release.
Functionality to be implemented in a future release.
7. wORD CLOCK INPuT
This connection allows the PCM92 to lock to a master system clock. It is
not terminated. For best results we recommend using “T” connectors when
setting up a BNC Word Clock network and terminating the end of of this
network with a 75 ohm BNC terminator.
This connection allows the PCM92 to lock to a master system clock. It is
not terminated. For best results we recommend using “T” connectors when
setting up a BNC Word Clock network and terminating the end of of this
network with a 75 ohm BNC terminator.
1
2
7
6
5
4
3