Lennox Hearth CI1500 Folheto

 

Part #775146M  Rev. A, 12/03, Page 1 of 2 

 

KIT CONTENTS: 
1 ea.  Blower Assembly 
1 ea.  Rheostat Assembly 
1 ea.  Fan Disc with 1 ea. White Wire 
5 ea.  Screws, #8 x ½” 
1 ea.  Instruction Sheet 
 
TOOLS REQUIRED: 
1/4” & 7/16” Nut Drivers or Sockets 
 
INSTALLATION INSTRUCTIONS: 
1. 

The following instructions, 1 through 11 
are for units WITHOUT an Optional Full 
Function Flame Modulating Remote 
Control System, H0301 or H0302. If either 
of these kits have been purchased, follow 
instructions on Page 2 instead – See 
INSTALLATION INSTRUCTIONS for units 
WITH a Full Function Flame Modulating 
Remote Control. 
 
Using a 1/4” nut driver or socket, install 
the Blower Assembly, using the 3 screws 
provided, to the bottom of the rear 
shroud as shown in Figure 1. 

 

 

 

 

2.  Disconnect the 2 black wires from the on/off 

switch at the valve (from terminals TP/TH 
and TH). See Figures 2 & 10. 

 

 

 

 

3.  Using a 7/16” nut driver or socket, remove 

the 4 bolts on the rear shroud as shown in 
Figure 3. Carefully lift off the shroud and 
turn it to the side (see Figure 4). 

 

 

 

4.  Using a ¼” nut driver install the fan disc 

with white wire onto the stove back 
(install with 2 existing screws as shown 
in Figure 4).  

 

 

 
 
5.  Pass the white wire from the fan disc 

through the hole in the rear shroud and 
connect it to the white rheostat wire (as 
shown in Figure 5). 

. 

 

 

 
Important Note: Ensure that the wires and 
connectors are completely through the hole 
and contained in the rheostat housing. 

6.  Locate the long black wire from the 

blower assembly and pass the wire 
through the hole in the rear shroud. Stow 
the wires into the existing wire holders 
on the inside of the rear shroud (see 
Figure 6a & 6b). 

 

 

 
 
7.  Connect the remaining black wire from the 

blower to the bottom terminal on disc as 
shown in Figure 7. 

 

 

 
 
8.  Slide the sleeves on the wires to cover the 

connectors on the fan disc as shown in 
Figure 8.