Invacare Electric Portable Patient Lift RPA600-1E Manual Do Utilizador
SECTION 6—TROUBLESHOOTING
26
SECTION 6—TROUBLESHOOTING
NOTE: If problems are not remedied by the suggested means, please contact your dealer or
Invacare.
Invacare.
SYMPTOMS
FAULTS
SOLUTION
Patient Lift feels loose.
Mast/Base joint loose.
Tie - Rods are loose.
Tie - Rods are loose.
Noisy or dry sound
from pivots.
from pivots.
Needs lubrication.
Electric actuator fails to
lift when button is
pressed.
lift when button is
pressed.
Hand-control or actuator con-
nector loose.
nector loose.
Battery low.
RED emergency stop button
pressed IN.
pressed IN.
Battery not connected prop-
erly to control box.
erly to control box.
The connecting terminals are
damaged.
damaged.
Electric actuator in need of ser-
vice or load is too high.
vice or load is too high.
Charge batteries. Refer to Charging the Battery
on page 18.
on page 18.
Rotate RED emergency stop button CLOCK-
WISE until it pops out.
WISE until it pops out.
Reconnect the battery to the control box. Refer
to Charging the Battery on page 18.
to Charging the Battery on page 18.
Replace the battery pack. Refer to Charging the
Battery on page 18.
Battery on page 18.
Refer to Replacing the Electric Actuator on
page 29. Contact your Dealer.
page 29. Contact your Dealer.
Unusual noise from
actuator.
actuator.
Actuator is worn or damaged
or spindle is bent.
or spindle is bent.
Refer to Replacing the Electric Actuator on
page 29. Contact your Dealer.
page 29. Contact your Dealer.
Lift arms will not lower
in uppermost position.
in uppermost position.
Lift arms require a minimum
weight load to lower from the
uppermost position.
weight load to lower from the
uppermost position.
Pull down slightly on the lift arms.
Lift arms will not lower
during a power retrac-
tion.
during a power retrac-
tion.
Shoulder bolt at the junction of
the boom and mast may not be
properly installed.
the boom and mast may not be
properly installed.