Intermec Technologies Scanner SF51 Manual Do Utilizador
Chapter 1 — Using the SF51
4
SF51 Cordless Scanner User’s Guide
Charging the Battery
Make sure you fully charge the battery before you start using the
SF51.
SF51.
To charge the battery
• Place the SF51 in the 1-bay charger (P/N 074645) or the
4-bay charger (P/N 074646). A fully discharged battery
charges to 100% capacity in approximately 3 hours.
charges to 100% capacity in approximately 3 hours.
It may take longer than 3 hours to charge the battery if the
temperature is near the minimum (0°C, 32°F) or maximum
(45°C, 113°F) charging temperature.
temperature is near the minimum (0°C, 32°F) or maximum
(45°C, 113°F) charging temperature.
Note: When you place the SF51 in the 1-bay or 4-
bay charger, you reset the SF51 scanner control
firmware. For more information, see “Resetting the
SF51” on page 28.
bay charger, you reset the SF51 scanner control
firmware. For more information, see “Resetting the
SF51” on page 28.
Checking the Battery Status
• Press the Scan button.
If the status light on the SF51 turns red, the battery is low
(less than 20% battery capacity remaining). You need to
charge the battery now.
(less than 20% battery capacity remaining). You need to
charge the battery now.
Understanding the Lights
The lights on the SF51 turn on to indicate the status of the
battery, a successful decode of a bar code, or the status of the
Bluetooth connection.
battery, a successful decode of a bar code, or the status of the
Bluetooth connection.