Intermec Technologies Scanner SF51 Manual Do Utilizador
Chapter 2 — Configuring and Managing the SF51
14
SF51 Cordless Scanner User’s Guide
To configure the SF51 from your Intermec computer
Note: When you connect to an Intermec computer,
all SF51 settings that are common to the Intermec
computer’s internal scanner settings are changed to
the default settings of the internal scanner.
all SF51 settings that are common to the Intermec
computer’s internal scanner settings are changed to
the default settings of the internal scanner.
1
Establish a Bluetooth connection with your Intermec
computer. For help, see the procedure “To connect to an
Intermec computer” on page 17.
computer. For help, see the procedure “To connect to an
Intermec computer” on page 17.
2
On your Intermec computer, start the Intermec Settings
application.
application.
3
Select Data Collection > SF51 Scanner Bluetooth Address,
where Bluetooth Address is the Bluetooth address of your SF51.
where Bluetooth Address is the Bluetooth address of your SF51.
4
Configure commands from the SF51 Scanner menu for your
SF51.
SF51.
5
Select File > Save Settings. The SF51 is updated with the
new configuration command settings.
new configuration command settings.
6
Close Intermec Settings.
Restoring Default Settings
You can restore the SF51 to its default settings by scanning the
Administrator Reset Factory Defaults command. For a list of the
default settings, see “Configuration Commands by Function” on
page 33.
Administrator Reset Factory Defaults command. For a list of the
default settings, see “Configuration Commands by Function” on
page 33.
Note: Using the Administrator Reset Factory
Defaults command resets all parameters. As a result,
you will lose Bluetooth communications.
Defaults command resets all parameters. As a result,
you will lose Bluetooth communications.
To restore default settings
• Scan this bar code:
Administrator Reset Factory Defaults
\60\08\55\22