Intermec Technologies Scanner SF51 Manual Do Utilizador

To increase decode security, you can have the scanner scan a bar 
code multiple times to ensure you have a valid read before 
transmitting the data.  

You can set Consecutive Same Read Data Validation from 0 to 
10. The default value of 0 sets the scanner to automatically 
adapt the consecutive same read based on the bar code quality 
and the trust level of the bar code. For example, labels with a 
check digit require less reads than labels without a check digit. 

This command disables all symbologies. Disabling all 
symbologies does not reset symbology parameters to their default 
values. To reset all symbology parameters to their default factory 
settings, use the Administrator Reset Factory Defaults 
command. For more information, see “Administrator Reset 
Factory Defaults” on page 36. 

Enables or disables the error beep. When you scan a 
configuration bar code that is damaged or unknown, you  
hear an error beep, and the configuration of the SF51 is not 
changed.  

Sets the length of the SF51 good read beeps. You can set Good 
Read Beep Duration to a value from 0 (off) to 2550 ms.  

Use Good Read Beep Duration in combination with Beep 
Volume and Beep Frequency to define beeps according to 
operator preference and work environment. 

Determines the number of beeps used for the good read beep: 1, 
2, or none.