Infortrend EONSTOR A16E-G2130-4 Manual Do Utilizador

EonStor A16E-G2130-4 Installation and Hardware Reference Manual  

 
 

  Install or replace the BBU module only with a BBU module 

supplied by your subsystem vendor. Use of battery cells 

provided by another source will void our warranty.    

  Always dispose of discharged or used batteries in an 

ecologically responsible manner. Dispose used BBUs at 

authorized battery disposal sites only. 

  Do not use nor leave the BBU near a heat source. Heat can 

melt the insulation and damage other safety features of battery 

cells, possibly leading it to acid leak and result in flames or 

explosion. 

  Do not immerse the BBU in water nor allow it to get wet. Its 

protective features can be damaged. Abnormal chemical 

reactions may occur, possibly causing functional defects, acid 

leak, and other hazardous results.  

  Do not disassemble or modify the BBU. If disassembled, the 

BBU could leak acid, overheat, emit smoke, burst and/or 

ignite. 

  Do not pierce the BBU with a sharp object, strike it with a 

hammer, step on it, or throw it. These actions could damage or 

deform it, internal short-circuiting can occur, possibly causing 

functional defects, acid leak, and other hazardous results.  

  If the BBU leaks, gives off a bad odor, generates heat, 

becomes discolored or deformed, or in any way appears 

abnormal during use, recharging or storage, immediately 

remove it from the subsystem and stop using it. If this is 

discovered when you first use the BBU, return it to Infortrend 

or your system vendor. 

To install a BBU into the controller module, please follow these steps: 

 

Step 

1. 

Prior to installing the BBU module, power off the 

subsystem or restart the subsystem after installation. For 

power off procedures, please refer to Section 4.4. 

 Step 2. 

Use a screwdriver to loosen the two (2) retention screws 

located on both sides of the dummy plate. (See Figure 2-

BBU Installation 

2-8