HP XC System Software 3.2.1 Manual Do Utilizador
4.6 Preparing the Hardware for CP3000BL Systems
Perform the following tasks on each server blade in the hardware configuration after the head
node is installed and the switches are discovered:
node is installed and the switches are discovered:
•
Set the boot order
•
Create an iLO2 user name and password
•
Set the power regulator
•
Configure smart array devices
Use the Onboard Administrator, the iLO2 web interface, and virtual media to make the
appropriate settings on HP ProLiant Server Blades.
appropriate settings on HP ProLiant Server Blades.
NOTE:
The following setup procedure continues from the procedure in
, in which you used a browser to log in to the Onboard
Administrator for the enclosure.
Setup Procedure
Use the following procedure to prepare the CP3000BL server blades:
1.
In the left frame of the HP Onboard Administrator browser window, click the plus sign (+)
next to Device Bays to display the list of nodes contained in the enclosure.
next to Device Bays to display the list of nodes contained in the enclosure.
2.
Click the link to the first hardware model in the list. Wait a few seconds until the frame to
the right is populated with node-specific information.
the right is populated with node-specific information.
3.
Click the Boot Options tab.
a.
a.
Select a boot device, and use the up and down arrows on the screen to position the
device so that it matches the boot order listed in
device so that it matches the boot order listed in
Table 4-20 Boot Order for HP ProLiant Server Blades
All Other Nodes
Head Node
Set the following boot order on all nodes except the
head node:
head node:
Set the following boot order on the head node:
1.
USB
1.
USB
2.
Floppy
2.
Floppy
3.
CD
3.
CD
4.
Hard Disk
4.
PXE NIC 1
5.
PXE NIC1
5.
Hard Disk
b.
Click the Apply button.
4.
In the left frame, do the following to create a new iLO2 user name and password on this
node:
a.
node:
a.
Under the hardware model, click iLO.
b.
In the body of the main window, click the Web Administration link to open the
Integrated Lights-Out 2 utility in a new window. You might have to turn off popup
blocking for this window to open.
Integrated Lights-Out 2 utility in a new window. You might have to turn off popup
blocking for this window to open.
c.
In the new window, click the Administration tab.
d.
In the left frame, click the User Administration link.
e.
Click the New button, and create a new iLO2 user name and password, which must
match the user name and password you set on the Onboard Administrator. Do not use
any special characters as part of the password.
match the user name and password you set on the Onboard Administrator. Do not use
any special characters as part of the password.
You use this user name and password whenever you need to access the console port
with the telnet cp-nodename command.
with the telnet cp-nodename command.
84
Preparing Individual Nodes