HP Cell Phone Accessories 8935 Manual Do Utilizador
36
Chapter 2
Testing AMPS Base Stations
Transmitter SAT Frequency and Deviation
Transmitter SAT Frequency and Deviation
This test measures the transmitter’s Supervisory Audio Tone (SAT)
frequency and deviation in the absence of any other modulating signal.
frequency and deviation in the absence of any other modulating signal.
Prerequisites
The following conditions must be met before testing:
❏ The Test Set is turned on and Preset was pressed to establish a
known instrument state.
❒ You have configured the Test Set for channel tuning (
❒ You have specified any gains or losses in your test system (
Test Procedure
1. Turn off the base station’s RF transmitter. A transmitter can be
damaged if it is not transmitting into a specified load, such as an
antenna, power amplifier, duplexer, or power meter with a 50
antenna, power amplifier, duplexer, or power meter with a 50
Ω
input impedance.
2. Verify that the transmitter’s rated RF power (or the level out of the
power amplifier if applicable) does not exceed the level printed next
to the Test Set’s RF IN/OUT connector.
to the Test Set’s RF IN/OUT connector.
3. Connect the transmitter’s RF output to the Test Set’s RF IN/OUT
port.
4. Turn off the voice modulation to the transmitter.
5. Turn off data modulation to the transmitter.
6. Enable SAT transmission.
7. Press
Shift
,
RF Anl
(AF Anl) to access the AF ANALYZER screen.
Main Menu