Honeywell VCR DCP200 Manual Do Utilizador
DCP200 Profile Controller & Recorder - Product Manual
51-52-25-150, Issue 1 – April 2009
Electrical Installation
Page 17
3 Field Upgrade Options
Options Modules and Functions
The available plug-in modules, options and accessories are shown in below:
Table 1. Options & Accessories
PART
NUMBER
DESCRIPTION
BOARD
IDENTIFICATION
NUMBER
OPTION SLOT 1
51453391-517
Single Relay Output for option slot 1
716/01
51453391-502
Single SSR Driver Output for option slot 1
716/02
51453391-503
Triac Output for option slot 1
716/03
51453391-504
Linear mA / Voltage Output module for option slot 1
639/01
OPTION SLOT 2 or 3
51453391-518
Single Relay Output for option slot 2 or 3
717/01
51453391-510
Dual Relay Output for option slot 2 or 3
644/01
51453391-507
Single SSR Driver Output for option slot 2 or 3
717/02
51453391-519
Dual SSR Driver Output for option slot 2 or 3
644/02
51453391-508
Triac module Output for slot 2 or 3
647/01
51453391-509
Linear mA / Voltage Output for option slot 2 or 3
640/01
51453391-111
24VDC Transmitter Power Supply for option slot 2 or 3
642/01
OPTION SLOT A
51453391-513
Digital Input for option slot A
641/02
51453391-515
Basic Auxiliary Input for option slot A
653/01
51453391-512
RS485 Serial Communications for option slot A
680/01
51453391-521
Ethernet Communications for option slot A
707/01
OPTION SLOT B
51453391-516
Full Auxiliary Input (inc digital input B) for option slot B
641/01
OPTION SLOT 4
51453391-520
4-Relay Output for option slot 4
703/01
ACCESSORIES
51453391-522
Blue Control PC Configuration Software & Lead
Note:
Modules can be either pre-installed at the time of manufacture, or retrofitted in the field.
CAUTION:
Plastic pegs prevent fitting of older non-reinforced single relay modules (Board
Identification Numbers 637/01 and 638/01). Fitting the older relay modules reduces
the isolation rating to Basic 240V Isolation and is therefore not recommended.
Remove this peg when fitting Dual Relay Modules.
Identification Numbers 637/01 and 638/01). Fitting the older relay modules reduces
the isolation rating to Basic 240V Isolation and is therefore not recommended.
Remove this peg when fitting Dual Relay Modules.
Note:
All dual relay modules have reinforced isolation.