Holux GPSmile Pocket PC Manual Do Utilizador

 

 

If the battery charge level becomes extremely low or the battery becomes 
flat, the memory data stored in Holux GPSmile 60 could be lost. 

When the low battery status icon or alarm message appears, immediately 
connect the AC adapter with Holux GPSmile 60 to charge the battery. 

• 

The removable battery gradually discharges even if Holux GPSmile 60 
is not being used. When Holux GPSmile 60 is left idle for a long time, the 
removable battery may change to will become flat. 

• 

It is recommended to save Holux GPSmile 60’s memory data to your PC 
or storage card. 

• 

The manufacturer is not responsible for the data change or clearance 
due to battery discharge. 

When using Holux GPSmile 60 for the first time, follow the initial setup 
procedures below, after the battery has been charged. When you slide the 
battery switch to the “supply” position

 and install the battery

, Holux GPSmile 

60 powers on automatically and the Welcome screen appears. Tap the 
screen to start the following setup. 

1.  Complete the touch screen correction. 

When the align screen appears, tap the center of the cross target with 
the stylus. The next target position changes upon tapping the target. 
Five taps completes the positioning correction. The screen then 
changes to the stylus screen. 

 

If an object touches the screen during correction, the 
correction is cancelled. Repeat the correction procedure. 

2.  Follow the on-screen instructions describing how to use the stylus, and 

then tap Next. 

 

 

For more information on stylus operation, see “Using the 
Stylus” earlier in this chapter. 

3.  Follow the pop-up menu instructions.