Hawking Technology 108G Manual Do Utilizador
75
want remove all PCs from the table, just click
"Delete All" button.
"Delete All" button.
Filter client PC by MAC address Check “Enable MAC Filtering” to enable MAC
Filtering.
Add PC
Fill in “Client PC MAC Address” and “Comment”
of the PC that is allowed to access the Internet, and
then click “Add”. If you find any typo before
adding it and want to retype again, just click
"Reset" and the fields will be cleared.
of the PC that is allowed to access the Internet, and
then click “Add”. If you find any typo before
adding it and want to retype again, just click
"Reset" and the fields will be cleared.
Remove PC
If you want to remove some PC from the "MAC
Filtering Table", select the PC you want to remove
in the table and then click "Delete Selected". If you
want remove all PCs from the table, just click
"Delete All" button. If you want to clear the
selection and re-select again, just click “Reset”.
Filtering Table", select the PC you want to remove
in the table and then click "Delete Selected". If you
want remove all PCs from the table, just click
"Delete All" button. If you want to clear the
selection and re-select again, just click “Reset”.
You can now configure other advance sections or start using the router (with the advance settings
in place)
in place)
Add PC
Parameters
Description
Client PC Description
The description for this client PC rule.
Client PC IP Addresses
Enter the IP address range that you wish to apply this
Access Control rule. This is the user’s IP address(es)
that you wish to setup an Access Control rule.
Access Control rule. This is the user’s IP address(es)
that you wish to setup an Access Control rule.
Note: You need to give your LAN PC clients a
fixed/static IP address for the Access Control rule to
work properly.
fixed/static IP address for the Access Control rule to
work properly.
Client PC Service
You can block the clients from accessing some
Internet services by checking the services you want
to block.
Internet services by checking the services you want
to block.
Protocol
This allows you to select UDP, TCP or both
protocol type you want to block.
protocol type you want to block.
Port Range
It can be assign up to five port ranges. The router
will block clients from accessing Internet services
that use these ports.
will block clients from accessing Internet services
that use these ports.