GSI Outdoors PNEG-1153 Manual Do Utilizador

d. Why take several samples? The electronics average the grain moisture and therefore 

it is possible to have a sample that is either wetter or dryer than the meter is reading (if 
the meter is changing rapidly while sampling).

e. Take samples at the discharge, not from the storage bin, when monitoring a drying 

operation. If you do not have a sampler at the discharge, contact your dealer and have 
one installed. See the following 

The Chart shows grain moisture readings (from a real situation) as they should be taken to 

obtain a realistic moisture value.

Question :   Where would you set the moisture offset, +0.3 or +0.6?

Answer   :   Most would want to set it to +0.3 which would make it match the point of
                    sale’s moisture reading.

5. The moisture Set Point is adjusted by turning the Set Point adjustment knob while holding 

the “Display Set Point” paddle switch down. Turning the knob clockwise will increase the 
moisture Set Point and counterclockwise will decrease the moisture Set Point (0 to 25).

6. Adjust the main speed adjustment knob to the desired discharge rate. This is the typical 

metering roll speed required to obtain the desired discharge moisture.

7. Switch the mode switch to “Automatic” and the Moisture/Matic will start to control the speed 

of the dryer metering rolls. The dryer will operate at “Low” speed when the moisture content 
displayed on the meter is wetter than 0.3 percent or more than the moisture Set Point. It 
will operate at “Main” speed when the moisture displayed is within +0.3 percent or -0.3 
percent of the moisture Set Point, and will run at “High” speed when the moisture is 0.3 
percent or more below the moisture Set Point.

9:33 AM

112

14.4%

109

14.7%

9.36 AM

112

14.4%

111

14.4%

9.38 AM

108

16.0%

107

17.5%

9.40 AM

110

14.6%

109

14.7%

9.43 AM

108

15.9%

104

17.3%

9.50 AM

111

14.5%

107

15.0%

89.8

93.6

15.0%

15.6%

15.3