GSI Outdoors PNEG-1153 Manual Do Utilizador

11. Plug in the printer control cable to the printer assembly.

12. Wire the printer power supply wire to the printer assembly. Connect the red wire to #1, 

green wire to #2. See 

 by connector.

13. To mount the plenum thermocouple, cut a hole in the plenum 1-1/4” diameter within fifty 

(50) feet of the control box. Secure the liquidtite and thermocouple using conduit clamps. 
Wire the sensor into the back connector pin #5 to white, pin #6 to red. See 

14. To mount the weather sensor, feed the cable through the 1-3/32" diameter hole in the 

bottom of the control box and secure with the electrical screw bushing. Have the sensor 
on the outside of the control box. Wire the cable to the black 36 pin connector, pins 7 
through 11. 

15. Put cable ties approximately every four (4)" to hold all the loose wires and cables in place. 

Do not tie any of these wires to the AC leads. Cut off the cable tie ends.

16. Remove the printer interface card DMC4 from its shipping box and install it in the new card 

slot with the black connector to the bottom. DO NOT lay this control card on any steel or 
conductive material.

17. Remove the shipping tape from the printer paper and spool.