Gerber Tools Saw 600 Manual Do Utilizador

3 – 12

The Pause menu is displayed after the cutting plotter has stopped, allowing you to alter the settings.

Press the 

 (PAUSE) key while cutting or plotting is in progress to stop cutting or plotting and display the

screen shown below.

In the Pause menu, alter settings as necessary.

Pressing the 

 (PAUSE) key cancels the pause function and restarts cutting or plotting.

This function allows the pen carriage to be moved from its current position in +100 mm steps along the X-

and Y-axes.

In READY mode, press the 

 key while holding down the 

 (ENTER) key to move the pen carriage in

+100 mm steps along the X- and Y-axes.

In READY or PAUSE mode, press the 

 key while holding down the 

 (ENTER) key to return the pen

carriage to the origin.

Test cutting can be performed after selecting the TOOL (cutter blade) and specifying the cutter-blade

length, OFFSET, FORCE, SPEED, and QUALITY settings to ensure that the selected cutting conditions

actually produce the desired cutting results. Check how far the blade cuts into the film and how corners are

being cut; if the cutting results are not satisfactory, reset the cutting conditions and repeat the test cutting

until the optimal settings are achieved. If you perform test cutting while the cutter-pen conditions are being

set, the test cutting will be performed under the conditions being set.

Original pen-carriage position

Moved pen-carriage
position

Y

X

100mm

100mm