Gigabyte 7014 Manual Do Utilizador
Rev. 051208
page 17 of 152
SERIAL INTERFACE
The 7014 Series switches provide an EIA-232 interface accessed via a 9 pin female connector (labeled
‘COM’ on the unit). This is used to access the Command Line Interpreter (CLI). The pin-outs are shown
below:
‘COM’ on the unit). This is used to access the Command Line Interpreter (CLI). The pin-outs are shown
below:
Serial Cable
Connect the serial COM port of your PC and the 7014 Series Switch using a standard straight through cable.
You will require a cable with a 9-pin or 25-pin sub-D female connector for the PC end, and a 9-pin male
sub-D connector for the 7014 Series end.
The following table shows the pin-out and the connections for both types of cable:
You will require a cable with a 9-pin or 25-pin sub-D female connector for the PC end, and a 9-pin male
sub-D connector for the 7014 Series end.
The following table shows the pin-out and the connections for both types of cable:
PC Port
25-Pin
9-Pin
7014 series
Female
Female
9-Pin Male
Signal Name
Pin #
Pin #
Pin #
Signal Name
TXD
2
3
3
RXD
RXD
3
2
2
TXD
GND
7
5
5
GND
Shielded cables and null modems are readily available from Radio Shack or a variety of computer stores.
HyperTerminal
The following configuration should be used in HyperTerminal:
Port Settings:
HyperTerminal
The following configuration should be used in HyperTerminal:
Port Settings:
115200
Data Bits:
8
Parity:
None
Stop bits:
1
Flow Control:
None