Galil DMC-1700 Manual Do Utilizador

 

The previous step showed the plot if the motion continued all the way to 5000, however partway through the motion, 
the object that was being tracked changed direction, so the host program determined that the actual target position 
should be 2000 cts at that time.  Figure 2 shows what the position profile would look like if the move was allowed to 
complete to 2000 cts.  The position was modified when the robot was at a position of 4200 cts.  Note that the robot 
actually travels to a distance of almost 5000 cts before it turns around.  This is a function of the deceleration rate set 
by the DC command.  When a direction change is commanded, the controller decelerates at the rate specified by the 
DC command.  The controller then ramps the velocity in up to the value set with SP in the opposite direction 
traveling to the new specified absolute position.  In Figure 3 the velocity profile is triangular because the controller 
doesn’t have sufficient time to reach the set speed of 50000 cts/sec before it is commanded to change direction.