Elation Professional 575E Manual Do Utilizador

Página de 54
 
 
 
Design Spot 575E™ 
©Elation Professional®                                                   5                       
                    
Design Spot 575E™ 
lamp should always be replaced at the end of their recommended duty cycle. Extreme 
caution should be used when operated this or any fixture fitted with a gas discharge lamp. 
 
Never open this fixture while in use! 
During the initial operation of this fixture, a light smoke or smell may emit from the interior of 
the fixture. This is a normal process and is caused by excess paint in the interior of the 
casing burning off from the heat associated with the lamp and will decrease gradually over 
time. 
 
This device falls under protection-class 1. Therefore it is essential that the device be 
grounded properly. 
 
All electrical connections must performed by qualified personal. 
 
Be sure the available voltage matches the voltage requirements of the unit. 
 
Be sure the power cord is never crimped or damaged. If the power cord is damaged, replace 
it immediately with a new one of similar power rating. 
 
Always disconnect from main power before performing any type of service or any cleaning 
procedure.  
 
Only handle the power cord by the plug. Never pull out the plug by tugging the wire portion of 
the cord. 
 
Please be aware that damages caused by manual modifications to the device are not 
subject to warranty.