Cuisine-Cookware ZBD6880 Manual Do Utilizador

18

Tea or coffee stains

Remove the stain by hand, using a solution  

of 1/2 cup bleach and 3 cups warm water.

Before cleaning 

interior, wait at least 20 minutes after a 
cycle for the heating element to cool 
down. Failure to do so can result in burns.

An overall yellow or brown

A special filter in the water supply line is 

film can be caused by iron 

the only way to correct this problem. 

deposits in water

Contact your GE dealer or a water softener 
company

Hard water minerals

GE recommends Jet Dry

Dishwasher 

Cleaner to help remove some hard water 
and mineral stains.

For extreme staining, clean the interior by 
applying dishwasher detergent to a damp 
sponge. Wear rubber gloves. DO NOT use
any type of cleanser other than those 
recommended or dishwasher detergent 
because it may cause foaming or sudsing. 
Cascade

, Cascade Complete

and 

Automatic Dishwashing 

Detergents have been approved for 
use in all Monogram Dishwashers.

Before cleaning 

interior, wait at least 20 minutes after a 
cycle for the heating element to cool 
down. Failure to do so can result in burns.

Low inlet water 

Make sure inlet water temperature is  

temperature

correct (see Using the Dishwasher 
section).

Select ADDED HEAT.

Select HEATED DRY.

Rinse agent dispenser is

Check and refill the rinse agent dispenser.

empty

Fuse is blown, or the

Replace fuse or reset circuit breaker. 

circuit breaker tripped

Remove any other appliances from the 
circuit.

Try resetting the START/RESET pad.

Wall switch 

Check for a wall switch that the dishwasher 

(some installations) is in 

might be connected to. A wall switch is

the “off” position

required by electrical codes in some 
localities. Turn the switch “on” if it is “off.” 

This is normal

Steam comes through the vent on the 
bottom of the door during drying and 
when water is being pumped out.

Before You Call For Service