Fujitsu 3400 Manual Do Utilizador

Using the Stylistic 3400 Pen Tablet

• Suspending system operation interrupts data communications; therefore, some

programs may block the system from suspending to prevent an interruption.

• The suspend action of the Suspend/Resume button may be disabled to prevent

accidental interruption. If this is the case, pressing the Suspend/Resume button
will not suspend system operation as described here. (In this case, suspend mode
can only be achieved using the system software). Contact your local help desk or
reseller if your system configuration is not suitable.

• If your system is equipped with a PC Card that allows you to connect to a wired

or wireless network, you may be logged off the network after a period of
inactivity while system operation is suspended. Contact your network
administrator or local help desk for details on log-off parameters for your
network.

Resuming System Operation

To resume system operation, (from either Suspend-to-RAM or Save-to-Disk modes),
press the Suspend/Resume button.

• From Suspend-to-RAM mode

Status lights indicate that the system state is changing. It may take up to a minute
before the system returns to the On state and system operation resumes. Note that
the display turns on shortly before the pen becomes active due to the power-up
sequences observed by the system.

• From Save-to-Disk mode

Active data is read from the hard disk drive, and the system returns to the On
state after a short period of time.

Note that power to several system components must be restored before system
operation resumes. Allow sufficient time for system operation to resume before
attempting to use the system. If your system uses Save-to-Disk mode, it will take
longer to resume operation as compared to using Suspend-to-RAM mode. Time is
needed to read data from the hard disk drive.

• Use the system as you normally would once system operation resumes.

All programs resume at the point where execution stopped when system operation
was suspended.