Fujitsu 3400 Manual Do Utilizador
24
Using the Stylistic 3400 Pen Tablet
3. Perform the calibration steps according to the instructions on the screen. The
calibration utility displays a cross-hair symbol in the middle and corners of the
screen, one corner at a time. Hold the pen as you normally would while using the
system and, as accurately as possible, tap the center of each crosshair as it is
displayed.
screen, one corner at a time. Hold the pen as you normally would while using the
system and, as accurately as possible, tap the center of each crosshair as it is
displayed.
A dialog box is displayed after you tap the last of the four cross-hair symbols. Tap
the screen within 20 seconds if you wish to save your new calibration settings. If
you don’t tap the screen within 20 seconds, the default calibration settings will be
used.
the screen within 20 seconds if you wish to save your new calibration settings. If
you don’t tap the screen within 20 seconds, the default calibration settings will be
used.
4. When the Verify New Pen Calibration Settings window appears, choose one of
the following steps.
• If you are satisfied that you tapped the cross-hairs accurately, tap Yes. The
taps that you performed in step 3 are then used to calibrate the screen.
• If you do not want to use the new calibration, tap No.
• If you want to enter a new calibration, tap Recalibrate. The calibration
instructions reappear.
If you have successfully performed the procedure above, the pen is now recalibrated,
and you can use the system as you normally would.
and you can use the system as you normally would.
Replacing the Pen
2
With use, the pen tip may become worn or may pick up foreign particles that can
scratch the screen. A damaged or worn tip may not move freely, causing
unpredictable results when using the pen. If your pen exhibits these problems,
replace the pen by contacting your reseller.
scratch the screen. A damaged or worn tip may not move freely, causing
unpredictable results when using the pen. If your pen exhibits these problems,
replace the pen by contacting your reseller.
Charging the Battery Pack
2
The Stylistic 3400 battery pack can be charged while it is installed in the pen tablet.
To do so:
1. Connect a DC power source, such as the AC adapter, to the DC input connector
on the pen tablet. The DC Input icon appears in the Status display. If the battery
pack charge level is below 90%, the battery pack begins charging and the
pack charge level is below 90%, the battery pack begins charging and the