FMC Corporation - Talstar FMC L06 Manual Do Utilizador
Doc No: OMM50000903
Rev: B Page 34 of 65
Subject to contractual terms and conditions to the contrary, this document and all the information contained herein are the confidential and exclusive
property of FMC Technologies, and may not be reproduced, disclosed, or made public in any manner prior to express written authorization by FMC.
10.3.1.3
Eccentric Discs
The second style of tool is more complex but capable of exerting more force on the
valve than the Knock Out Tool. This style can be used on all sizes of the AR valves in
all of the pump models. The discharge valve is removed first. The valve must be
disassembled with the cage, spring and valve body removed from the fluid cylinder prior
to the seat being pulled. A special hex drive tool will assist in removing the cage from
the seat.
valve than the Knock Out Tool. This style can be used on all sizes of the AR valves in
all of the pump models. The discharge valve is removed first. The valve must be
disassembled with the cage, spring and valve body removed from the fluid cylinder prior
to the seat being pulled. A special hex drive tool will assist in removing the cage from
the seat.
Figure 7: Valve Disassembly
Cage Removal Tool
Hex to be used with a
socket to apply torque
socket to apply torque
Lugs to fit over cage
Valve Cage, removed by
unthreading it from the seat.
Removal is counterclockwise viewed
from the top.
unthreading it from the seat.
Removal is counterclockwise viewed
from the top.
Valve Seat