Ciprico Rimfire 3880 Manual Do Utilizador
User’s Guide
21020285 D
Chapter 7 Board-control Commands
General Options (07H)
Page 7 - 17
PAR Check SCSI Bus Parity
- This bit allows you to select whether the
adapter checks errors in parity that occurred on the SCSI bus. (The default is
set by SCSI configuration jumpers. See Chapter 3.)
set by SCSI configuration jumpers. See Chapter 3.)
0
⇒
Do not check for parity.
1
⇒
Check for SCSI parity errors.
Note
Use the option that sets
the adapter to always
perform Block Mode
transfers only when you
are providing User-
defined Address
Modifiers that do Block
Mode Transfers.
Use the option that sets
the adapter to always
perform Block Mode
transfers only when you
are providing User-
defined Address
Modifiers that do Block
Mode Transfers.
BMT Block Mode Transfers
- This bit allows you to force the adapter to
perform Block Mode transfers regardless of the Address Modifier used.
0
⇒
The RF3880 performs Block Mode transfers for only those Address
Modifiers listed in the VME specification.
1
1
⇒
The RF3880 performs Block Mode transfers regardless of the Address
Modifier.
Bit 3
- Please note that Bit 3 has meaning for other Ciprico adapters that are
compatible with the RF3880, but this bit is ignored on the RF3880.
Command Code
The command code for this command is 07H.