Chief Outboard Motor SL236 Manual Do Utilizador
Service Manual
SL236 Motor Replacement
3
REMOVING MOTOR
1.
Fully lower SL236, if possible.
2.
Turn off and remove power from SL236.
3.
Remove projector from SL236 following instructions
included with the SL236.
included with the SL236.
4.
Remove signal and power cables from projector.
5.
Remove projector cradle by removing four locking nuts (two
on each side) and additional washers and spacers. (See
Figure 1)
on each side) and additional washers and spacers. (See
Figure 1)
Figure 1
6.
Remove six screws (three on each side) from plate and
remove plate for easier access to motor area. (See
Figure 2)
remove plate for easier access to motor area. (See
Figure 2)
7.
Restore power to SL236.
8.
Run the lift up or down until the set screws on the motor
couplers face outward so they can be removed in a later
step. (See Figure 3)
couplers face outward so they can be removed in a later
step. (See Figure 3)
9.
Remove power from SL236.
IMPORTANT ! : Do NOT remove set screws yet.
Figure 2
Figure 3
5
x 4
5
Remove
plate
plate
6
x 6
Remove plate
Motor
Coupler
Coupler
Set Screws
6